Alcatel-Lucent 7450 Basic System Configuration Manual page 430

System Command Reference
Description This command configures the time the service manger waits after a node reboot before running the DF
election algorithm. The boot-timer value should be configured to allow for the BGP sessions to come
up and for the NLRI information to be refreshed/exchanged.
The no form of the command reverts the default.
Default
no boot-timer
Parameters
seconds — Specifies the BGP multi-homing boot-timer in seconds.
cert-sync
Syntax [no] cert-sync
Context admin>redundancy
Description
This command automatically synchronizes the certificate/CRL/key when importing or generating (for
the key). Also if a new CF card is inserted into slot3 into the backup CPM, the system will sync the
whole system-pki directory from the active CPM. This command applies only to the 7450 ESS and
7750 SR.
Default
enabled
force-switchover
Syntax force-switchover [now] [ignore-status]
Context admin>redundancy
Description
This command forces a switchover to the standby CPM card. The primary CPM reloads its software
image and becomes the secondary CPM.
Parameters
now — Forces the switchover to the redundant CPM card immediately.
ignore-status — Forces a switchover despite any diagnostics or conditions on the standby. For
mgmt-ethernet
Syntax mgmt-ethernet [revert seconds]
no mgmt-ethernet
Context configure>redundancy
430
Values
1 to 100
the 7950 XRS, this is true even if the standby cannot reach the extension CPMs on the
extension chassis of an XRS-40 via its local CPM interconnect ports).
Basic System Configuration Guide