Alcatel-Lucent 7450 Basic System Configuration Manual page 527

Basic System Configuration Guide
Table 70: System Timing Output (Continued)
Label
System Quality Level
Current Frequency
Offset
Reference Order
Reference Mate CPM
Admin Status
Quality Level
Override
Rx Quality Level
Qualified for Use
Description (Continued)
• Mate CPM (none) - show>system>sync-if-timing>standby
when standby locked to active which is freerun or holdover - (for
all chassis)
• Mate CPM (ref1), Mate CPM (ref2) - show>system>sync-if-
timing>standby when standby locked to active which is locked
to ref1 or ref2:
→ 7750 SR-7/12
→ 7450 ESS-7/12
→ 7750 SR-12e
→ 7750 SR-1e/2e/3e
→ 7750 SR-a4/8
→ 7950 XRS-16/20/40
• BITS 1, BITS2 - (7750 SR-c4 only)
Indicates the quality level being generated by the system clock.
(value)
The frequency offset of the currently selected timing reference in parts per
million.
ref1, ref2, bits — Indicates that the priority order of the timing references.
Data within this block represents the status of the timing reference
provided by the Mate CPM. This will be the BITS input from the standby
CPM.
down — The ref1 or ref2 configuration is administratively shutdown.
up — The ref1 or ref2 configuration is administratively enabled.
diag — Indicates the reference has been forced using the force-reference
command.
Indicates whether the QL value used to determine the reference was
configured directly by the user.
Indicates the QL value received on the interface.
• inv - SSM received on the interface indicates an invalid code for
the interface type.
• unknown - No QL value was received on the interface.
Indicates whether the reference has been qualified to be used as a source
of timing for the node.
System Management
527