Common Configuration Tasks
?
If the active and standby are not synchronized for some reason, users can manually
synchronize the standby CPM by rebooting the standby by issuing the admin reboot standby
command on the active or the standby CPM.
Configuring Synchronization Options
Network operators can specify the type of synchronization operation to perform between the
primary and secondary CPMs after a change has been made to the configuration files or the
boot environment information contained in the boot options file (BOF).
Use the following CLI to configure the boot-env option:
CLI Syntax:
Example:
The following displays the configuration:
A:ALA-12>config>system# synchronize boot-env
A:ALA-12>config>system# show system synchronization
===================================================
Synchronization Information
===================================================
Synchronize Mode
Synchronize Status
Last Config Sync Time
Last Boot Env Sync Time : 2006/06/27 06:19:47
===================================================
A:ALA-12>config>system#
Use the following CLI to configure the config option:
CLI Syntax:
Example:
The following example displays the configuration.
A:ALA-12>config>system# synchronize config
A:ALA-12>config>system# show system synchronization
===================================================
Synchronization Information
308
config>system
synchronize {boot-env|config}
config>system# synchronize boot-env
: Boot Environment
: No synchronization
: 2006/06/27 06:19:47
config>system
synchronize {boot-env|config}
config>system# synchronize config
Basic System Configuration Guide