Alcatel-Lucent 7450 Basic System Configuration Manual page 299

Example:
Authentication-key
The authentication-key command configures an authentication key-id, key type, and key
used to authenticate NTP PDUs sent to and received from other network elements
participating in the NTP protocol. For authentication to work, the authentication key-id,
authentication type and authentication key value must match.
CLI Syntax:
Example:
The following example shows NTP disabled with the authentication-key parameter enabled.
A:sim1>config>system>time>ntp# info
----------------------------------------------
----------------------------------------------
A:sim1>config>system>time>ntp#
Broadcast
The broadcast command is used to transmit broadcast packets on a given interface.
Interfaces in the base routing context or the management interface may be specified. Due the
relative ease of spoofing of broadcast messages, it is strongly recommended to use
authentication with broadcast mode. The messages are transmitted using a destination address
that is the NTP Broadcast address.
CLI Syntax:
Example:
Basic System Configuration Guide
config>system>time>ntp#
config>system>time>ntp# authentication-check
config>system>time>ntp# no shutdown
config>system>time>ntp
authentication-key key-id {key key} [hash |
hash2] type
{des | message-digest}
config>system>time>ntp#
config>system>time>ntp# authentication-key 1 key A type
des
config>system>time>ntp# no shutdown
shutdown
authentication-key 1 key "OAwgNUlbzgI" hash2 type des
config>system>time>ntp
broadcast [router router-name] {interface
ip-int-name} [key-id key-id] [version
[ttl ttl]
config>system>time>ntp#
version]
System Management
299