Alcatel-Lucent 7450 Basic System Configuration Manual page 397

zone
Syntax zone [std-zone-name | non-std-zone-name] [hh [:mm]]
no zone
Context config>system>time
Description
This command sets the time zone and/or time zone offset for the device.
The SR-series router OS supports system-defined and user-defined time zones. The system-defined
time zones are listed in
For user-defined time zones, the zone and the UTC offset must be specified.
The no form of the command reverts to the default of Coordinated Universal Time (UTC). If the time
zone in use was a user-defined time zone, the time zone will be deleted. If a
been configured that references the zone, the summer commands must be deleted before the zone can
be reset to UTC.
Default
zone utc - The time zone is set for Coordinated Universal Time (UTC).
Parameters
std-zone-name — The standard time zone name. The standard name must be a system-defined
non-std-zone-name — The non-standard time zone name.
hh [:mm] — The hours and minutes offset from UTC time, expressed as integers. Some time
Basic System Configuration Guide
Table
zone in Table 29. For zone names in the table that have an implicit summer time setting, for
example MDT for Mountain Daylight Saving Time, the remaining start-date, end-date and
offset parameters need to be provided unless it is necessary to override the system defaults
for the time zone.
For system-defined time zones, a different offset cannot be specified. If a new time zone is
needed with a different offset, the user must create a new time zone. Note that some system-
defined time zones have implicit summer time settings which causes the switchover to
summer time to occur automatically; configuring the
A user-defined time zone name is case-sensitive and can be up to 5 characters in length.
Values
A user-defined value can be up to 4 characters or one of the
following values:
GMT, BST, IST, WET, WEST, CET, CEST, EET, EEST, MSK,
MSD, AST, ADT, EST, EDT, ET, CST, CDT, CT, MST, MDT,
MT, PST, PDT, PT, HST, AKST, AKDT, WAST, CAST, EAST
Values
Up to 5 characters maximum.
zones do not have an offset that is an integral number of hours. In these instances, the minutes-
offset must be specified. For example, the time zone in Pirlanngimpi, Australia UTC + 9.5
hours.
Default
hours: 0
minutes: 0
Values
hours: -11 — 11
minutes: 0 — 59
29.
System Management
dst-zone
dst-zone parameter is not required.
command has
397