Communications Module Firmware Versions; Communications Module Firmware Version; Mj-Xl Communications Module Firmware Versions - Siemens MJ-4 Series Installation Manual

84 SF = 1
85 SF = 1
86 SF = 1
87 SF = 1
88 SF = 1
89 SF = 1
90 SF = 1
91 SF = 1
92 SF = 1
93 SF = 1
94 SF = 1
95 SF = 1
96 SF = 1
97 SF = 1
98 SF = 1
99 SF = 1

9 Communications Module Firmware Versions

9.1 MJ-4 Communications Module firmware version
Version 3.10 : Supports all DNP points including Set 7, supports AMD Flash memory.

9.2 MJ-XL Communications Module firmware versions

The principle firmware version released for the MJ-4 Communications Module is the 3.10, an abbreviated list of the
principle firmware versions that have were released for use on the MJ-X
questions regarding firmware versions not included in this list, please contact your Siemens representative.
Version 2.13: Contains "full set" of 370 DNP3.0 points (see 2.x3 points list in Section 8.2.9).
Version 2.14: Contains "limited set" of 64 DNP3.0 points (see 2.x4 points list in Section 8.2.3).
Version 3.01: Level 2 implementation of DNP3.0, no DNP points by default; must use the DNP Configure program
to load the desired DNP points onto the control panel. Supports unsolicited responses.
Version 3.07: Level 2 implementation of DNP3.0, can use DNP Configure program to load user-defined DNP points
or choose to use one of the predefined DNP point sets (if used in conjunction with MJXL version 3.07
or higher).
Version 3.0701: Added short delay after CM initialization so all values are online before polling can start
Version 3.0702: Added full support for Trip/Close operations on Binary Outputs. If using a Trip/Close operation for
a tap raise or lower, the TRIP command should be used to activate. Also, a Trip to the Tap Raise
point will raise the tap one position; a Close to the Tap Raise point will lower the tap one position.
Version 3.0703: Added support for alternate AMD flash memory. Removed support for ATMEL Flash memory.
34
Memo2 - chars 9-10
"NN" Raise/Lower Value
Regulator Id (Range: 0 - 32766)
Tap Changer Mechanism
Max. Load Current % (Range: 0-350)
Full Load Current (50-7200) (A)
CM Pre-tx delay for DNP
CM Post-tx delay for DNP
CM transmit delay for DNP
CM number of retries (DNP)
CM protocol
CM parity
CM self test request
Raise Limit % (0=10%, 1=8.75%, 2=7.5%, 3=6.25%, 4=5%)
Lower Limit % (0=10%, 1=8.75%, 2=7.5%, 3=6.25%, 4=5%)
Data Port Baud
L
communications module follows. For