X524 Electronic Power Supply; Meanings Of Leds On The Sensor Module Cabinet-Mounted (Smc30) - Siemens SINAMICS DCM Operating Instructions Manual

Additional system components
7.2 Sensor Module Cabinet-Mounted SMC30
7.2.3.6

X524 electronic power supply

Table 7- 8 X524 terminal strip
Terminal
+
+
M
M
Terminal type: Spring-loaded terminal
Connectable conductor cross-section: Flexible, 0.08 mm
Stripped length: 8 to 9 mm
Tool: 0.4 × 2.0 mm screwdriver
Note
The two "+" or "M" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
7.2.3.7

Meanings of LEDs on the Sensor Module Cabinet-Mounted (SMC30)

Table 7- 9 Sensor Module Cabinet SMC30 – description of the LEDs
LED Color
RDY -
READY
Green
Orange
Red
Green/re
d
Green/re
d
Green/or
ange
or
Red/oran
ge
156
Function
Electronics power supply
Electronics power supply
Electronics ground
Electronics ground
State
Off Electronics power supply is missing or outside permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
light CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous At least one fault is present in this component.
light
Note:
The LED is activated regardless of whether the
corresponding messages have been reconfigured.
Flashing, Firmware is being downloaded.
0.5 Hz
Flashing, 2 Firmware download is complete. Wait for POWER ON.
Hz
Flashing Component recognition via LED is activated (p0144).
Note:
Both options depend on the LED status when component
recognition is activated via p0144 = 1.
Technical data
Voltage: 24 V (20.4 – 28.8 V)
Power consumption: Max. 0.55 A
Max. current across
jumper in connector: 20 A at 55 °C
to 2.5 mm
2 2
Description, cause
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
SINAMICS DCM Control Module