Siemens SINAMICS DCM Operating Instructions Manual page 264

Operation
9.1 Basic information
An optional Memory Card is used:
● For saving various parameter data sets
● For transferring the parameter data sets to additional SINAMICS DCM drives
● For series commissioning
The Memory Card is mandatory:
● For installing software updates
● For using an AOP30 in languages other than German and English
● To use the function "SINAMICS Link" (see Chapter "Communication via SINAMICS Link")
Parameter data sets
Parameter data sets represent all of the the parameters of a project - including the DCC
charts and the project itself. Parameter data sets differ on the basis of drive configuration
(power unit, motor, encoder, etc. used) and application (e.g. function modules, type of
control).
Different amounts of data can be saved in the 3 memory areas:
● ROM: Four parameter data sets with the indices 0, 10, 11, and 12
● The parameter data set with the index 0 is active in the RAM
● Memory card: Depending on the free storage space, up to 101 parameter data sets
Note
The DCC library itself is not saved as a part of the parameter data set.
264
Note
The memory card supplied from Siemens as option S01 or S02 includes, when supplied,
a dump of the internal unit software. These files are only required to update software.
These files can be deleted for other applications. Before you use the card for the
functions described in this chapter, copy these files to a local folder of your PG/PC and
delete the files on the memory card.
(indices 0 to 100)
SINAMICS DCM Control Module
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619