Runtime (Operating Hours Counter) - Siemens SINAMICS DCM Operating Instructions Manual
Control module for variable-speed dc drives
Hide thumbs
Also See for SINAMICS DCM:
- List manual (1205 pages) ,
- Operating instructions manual (715 pages) ,
- Manual (705 pages)
Table of Contents
Advertisement
Descriptions of functions
10.27 Runtime (operating hours counter)
10.27
Runtime (operating hours counter)
Total system runtime
The total system runtime is displayed in r2114 (Control Unit).
● Index 0 = System runtime in ms.
● Index 1 = System runtime in days.
Relative system runtime
The relative system runtime since the last POWER ON is displayed in p0969 (Control Unit)
in ms. The counter runs over after 49 days.
446
After reaching 86400000 ms (24 h), the value is reset.
The counter value is saved at switch off. After the drive unit is powered up, the counter
continues to run with the most recently saved value.
Note
Errors and alarms are stamped with this system runtime.
If a connected AOP30 is parameterized as the time-of-day master (see Chapter 9,
"Assigning parameters to AOP30 as the time-of-day master"), faults and alarms are
provided with a real-time stamp.
SINAMICS DCM Control Module
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
Advertisement
Table of Contents
