Siemens SINAMICS DCM Operating Instructions Manual page 506

Index
Q
Quick stop, 370
R
Ramp-down time, 374
Ramp-function generator, 374
Ramp-function integrator, 377
Ramp-function-generator tracking, 378
Rampup time, 374
Removing modules, 43
Replacing
Operator panel battery, 478
Replacing the Backup Battery of the Cabinet Operator
Panel, 478
Restart, 413
Ribbon cables, 137
S
Safety shutdown (E-STOP), 373
Series connection
6-pulse, 426, 428, 430, 432
Setpoint channel
Creep, 380
Fixed setpoint, 381
Jog, 379
Ramp-function generator, 374
Shipbuilding, 481, 483
Shutdown, 368
OFF2 (disconnection), 370
OFF3 (quick stop), 370
SINAMICS Link, 357
Single-phase line supply, 414
Slave-to-slave communication
PROFIBUS, 319
SMC30, 143, 242
Software update, 472
Speed controller, 390
Adaptation, 390
Droop, 390
Reference model, 390
Start pulse, 390
Speed-dependent current limitation, 409
STARTER, 210
Commissioning, 211
Configuring a drive unit, 219
Connection through a serial interface, 234
Creating the project, 212
Installation, 210
Online mode via PROFINET, 337
506
Project wizard, 213
Starting the drive project, 232
User interface, 211
Status display at the BOP20, 500
Status word, 317
Status word for encoder, 388
Switch on, 368
Operation enable (enable), 372
T
Technical data
Communication Board CBE20, 148
Sensor Module Cabinet-Mounted SMC30, 161
Terminal Module TM15, 176
Terminal Module TM31, 192
Unit data, 35
Technology controller, 396
Temperature sensor, 121
Terminal Module TM15, 165, 240
Terminal Module TM31, 178, 240
Terminals
Arrangement, 111
Thermal overload protection, 404
Thyristor diagnostics, 448
Time-of-day master, 306
Timeout monitoring, 302
TM15, 143
TM31, 143
Trend recorder function, 447
U
Unit data, 35
Unit fan
Operating hours counter, 403
Upgrading
Software release, 472
USS interface, 363
X
X_I_IST, 124
X100, X101, 126
X11 ... X26, 131
X126, 126, 310
X177, 120
X178, 125
X179, 125
X21A, X21PAR, 137
X22A, X22PAR, 138
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
SINAMICS DCM Control Module