Siemens SINAMICS DCM Operating Instructions Manual page 203

〈15〉Documentation of set values
The following facilities are available so that the settings made can be recorded outside the
unit:
● External Memory Card was inserted during the RAM to ROM (p0977=1). The parameters
● Write the parameters to a Memory Card (p0804).
● Document the parameters in a STARTER project (load to PG). Also refer to the
SINAMICS DCM Control Module
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
were therefore also transferred to the external Memory Card.
"Operation" chapter, "Memory Card functions" section and "Commissioning with the
STARTER commissioning tool" chapter.
8.2 Commissioning using the BOP20 Operator Panel
Commissioning
203