Siemens SINAMICS DCM Operating Instructions Manual page 207

p50102[d]
p50103[d]
p50114[d]
When you have finished entering the motor data, choose "Continue" underneath the final
parameter value and activate with <F5> (OK).
Encoder selection
p50083[d]
Analog tachometer screen
p50741[d]
p2000
Pulse encoder screen
p0400[e]
p0404[e]
p0405[e]
p0408[e]
p2000
EMF controlled screen
p50115[d]
p2000
Freely wired screen
p50609[c]
p2000
DRIVE-CLiQ encoder screen
p0400[e]
p0404[e]
p0405[e]
p0408[e]
p2000
SINAMICS DCM Control Module
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
Rated excitation current
Minimum excitation current (optional)
Thermal time constant for motor
See the section titled "Thermal overload protection for the DC motor (I2t
monitoring of the motor)"
Actual speed controller value selection
Tachometer voltage at maximum speed
Reference speed
Encoder type selection
Encoder configuration active
Square-wave encoder A/B
Rotary encoder pulse no.
Reference speed
EMF at maximum speed
Reference speed
Actual speed controller value signal source
Reference speed
Encoder type selection
Encoder configuration active
Square-wave encoder A/B
Rotary encoder pulse no.
Reference speed
8.3 Commissioning using the AOP30 Operator Panel
Commissioning
207