Siemens SINAMICS DCM Operating Instructions Manual page 235

Control module for variable-speed dc drives

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

1. In STARTER, from Project > Set PG/PC interface, select the Serial cable (PPI) interface.

2. Enter the following settings. The "0" address and the transmission rate 19.2 kbit/s are

SINAMICS DCM Control Module

Operating Instructions, 06.2010, C98130-A7067-A1-02-7619

If this is not available in the dropdown list, you first have to add it using Select.

If the interface cannot be added to the selection menu , the drive for the serial interface

still needs to be installed.

This is located in the following path on the STARTER CD:

\installation\starter\starter\Disk1\SerialCable_PPI\

STARTER must not be active while the driver is being installed.

important here.

Setting up the interface

8.4 Commissioning with the STARTER commissioning tool

Commissioning