Activating Online Through Parameters - Siemens SINAMICS DCM Operating Instructions Manual

Control module for variable-speed dc drives

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Commissioning

8.5 Activating function modules

Accept the settings by clicking OK.

The function modules are also correspondingly set in the drive by connecting online and

downloading.

Activating online through parameters

This process is not supported by STARTER because it uses its own mechanisms.

Activation is through p0108. r0108 and is available at each DO as a display parameter for

the activated function modules.

The setting is made on p0108[i] in the Control Unit. In this case, the index corresponds to the

Index 0 stands for the CU,

Index 1 for the first DO – the default is the closed loop control DO DC_CTRL,

Index 2 optionally the first TMxx, etc.

Selecting the function modules

SINAMICS DCM Control Module

Operating Instructions, 06.2010, C98130-A7067-A1-02-7619