Connection Through A Serial Interface - Siemens SINAMICS DCM Operating Instructions Manual

Commissioning
8.4 Commissioning with the STARTER commissioning tool
NOTICE
Your project data has now been transferred to the drive unit. Presently, this data is only in
the volatile memory (RAM) of the drive unit, however, neither saved in the non-volatile
memory (ROM) nor on an optionally inserted memory card (see also Chapter "Memory card
functions").
To save your project data in the ROM and on the optionally available memory card of your
drive unit so that it is protected against power failure, carry out the following steps.
Step
Note
The button for copying RAM to ROM can only be activated if the drive unit has been marked
in the project navigator.
Results of the preceding steps
● You have generated a project for your drive unit using the STARTER offline
● You have saved your project data to your PC hard drive
● You have transferred your project data to the drive unit
● You have saved your project data in your drive unit's FLASH memory so that it is backed
8.4.2.4

Connection through a serial interface

Along with the connection through the PROFIBUS, there is also a facility for data exchange
via the serial interface.
Preconditions
● A serial interface (COM) must be available on the PC from which the connection will be
● An AOP30 must not be connected with the drive.
234
3 Select the menu command
Target system > Copy RAM to ROM
up in the event of a power failure
made.
SINAMICS DCM Control Module
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
Selection in the
toolbar