X500 And X501 Drive-Cliq Interface; X524 Electronic Power Supply - Siemens SINAMICS DCM Operating Instructions Manual

Additional system components
7.4 Terminal Module TM31
7.4.3.3

X500 and X501 DRIVE-CLiQ interface

Table 7- 24 DRIVE-CLiQ interfaces X500 and X501
Pin
1
2
3
4
5
6
7
8
A
B
Blanking plate on DRIVE-CLiQ interface: Yamaichi company, Order No.: Y-ConAS-13
7.4.3.4

X524 electronic power supply

Table 7- 25 Terminals for the electronic power supply
Terminal
+
+
M
M
Note
The two "+" or "M" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
The power consumption increases by the value for the DRIVE-CLiQ node and digital
outputs.
182
Signal name
TXP
TXN
RXP
Reserved, do not use
Reserved, do not use
RXN
Reserved, do not use
Reserved, do not use
+ (24 V)
M (0 V)
Designation
Electronic power supply
Electronic power supply
Electronics ground
Electronics ground
Technical specifications
Transmit data +
Transmit data -
Receive data +
Receive data -
Power supply
Electronics ground
Technical data
Voltage: 24 VDC (20.4 – 28.8 V)
Power consumption: Max. 0.5 A
Max. current via bridge in connector:
20 A at 55 ℃
Operating Instructions, 06.2010, C98130-A7067-A1-02-7619
SINAMICS DCM Control Module