Connection To X524 Electronics Power Supply - Siemens SINUMERIK 828D Series Software And Hardware Service Manual

4.19.7

Connection to X524 electronics power supply

Secondary conditions for DMC20 with UL approval
Pin assignment of the cable for connection to X524:
Address where the cables can be sourced
The following cables can be sourced through: Phoenix Contact
www.phoenixcontact.com/online/portal/pc)
Pre-assembled cables
Sensor/actuator cable, 5-pole, free cable end at
the M12-SPEEDCON straight socket
Length of cable: 2, 5, 10, 15 m (up to 100 m on
request)
SAC-5P-xxx-186/FS SCO
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1
Pin Designation
1 (brown) Electronics power supply
2 (white) Electronics power supply
3 (black) Electronics ground
4 (blue) Electronics ground
5 (gray) Not connected
Service cases - hardware
Technical specifications
The supply voltage of 20.4 V – 28.8
V refers to the terminal voltage at the
DME20.
The cable cross-section and the
power supply cable length should be
observed:
● Pins 1 and 2 are internally
jumpered.
● Pins 3 and 4 are internally
jumpered.
(https://
Cables to be assembled by the user
Cable ring, PUR/PVC black, 5-pole
Conductor colors: brown/white/blue/black/gray
Cable length: 100 m
Conductor cross-section: 5 x 0.75 mm²
SAC-5P-100.0-186/0.75
Article number: 1535590
Connector:
Sensor/actuator connector, socket, straight, 5-pin,
M12, A-coded
Screw connection, metal knurl, Pg9 cable gland
SACC-M12FS-5CON-PG9-M
Article number: 1681486
4.19 Hub Modules
233