Installation - Epson RC90 Manual

3.2.2 Installation

Install the controller on a flat surface such as wall, floor, and controller box in the
direction shown from (A) to (C).
(A) Flat Mounting
(B) Upright Mounting
* The rubber foot needs to be replaced.
For installing the Controller to the Controller box or the base table, process screw holes as
NOTE

follows.
Ensure the draft around the in/out and prevent the other equipments, walls and install the
Controller by keeping the distance as follows for maintenance.
Air flow of the Controller Fan
- Hot air with higher temperature than the ambient temperature (about 10 deg.C) comes
out from the Controller. Make sure that heat sensitive devices are not placed near the
outlet.
- Arrange the cables in front of the Controller so that you can pull the Controller forward.
RC90 (EPSON RC+ 7.0) Rev.8
463 mm
50 mm
100 mm
Excluding the installation
side such as base table
Setup & Operation 3. Installation
(C) Rack Mounting
* Rack-mount plate is required.
133.35 mm
200 mm
100 mm
50 mm
19