Epson RC90 Manual page 213

No.
7713 Option not enabled
7714 File not found.
Robot number is out of the available
7715
range.
7716 Robot does not exist.
7717 File Error. Invalid folder.
Simulator.
7750 Cannot execute due to the initialization
process failure.
Simulator.
7751
File save failure.
Simulator.
7752
File read failure.
Simulator.
7753
Memory mapping failure.
Simulator.
7754 Virtual controller information already
exists.
Simulator.
7755 Virtual controller information creation
failure.
Simulator.
7756 Copy source of the virtual controller
information does not exist.
Simulator.
7757 Copy destination virtual controller
information already exists.
Simulator.
7758 Failed to copy the virtual controller
information.
Simulator.
7759 Failed to delete the virtual controller
information.
Simulator.
7760 Failed to delete the controller
information.
Simulator.
7761 Failed to rename the controller
information.
Simulator.
7762 Virtual controller information to be
renamed does not exist.
Simulator.
7763 Renamed virtual controller information
already exists.
Simulator.
7764
Manipulator number is incorrect
Simulator.
7765 Failed to read the manipulator definition
file.
Simulator.
7766
Failed to copy the layout object.
Simulator.
7767
Failed to cut the layout object.
RC90 (EPSON RC+ 7.0) Rev.8
Message Remedy
Enable the option.
Specify the correct file name.
Check the robot number.
Check whether the robot is registered.
Check the folder name.
Reboot the RC+.
Reboot the RC+.
Reboot the RC+.
Reboot the RC+.
Name of the virtual controller may be
duplicated. Check the controller
name.
Reboot the RC+.
Check the virtual controller name.
Name of the virtual controller may be
duplicated. Check the controller
name.
Reboot the RC+.
Reboot the RC+.
Reboot the RC+.
Check the virtual controller name.
Check the virtual controller name.
Check the virtual controller name.
Reboot the RC+.
Check if the definition file exists.
Reboot the RC+.
Reboot the RC+.
Maintenance 9. Troubleshooting
Note 1 Note 2
197