Epson RC90 Manual page 205

No. Message
Specified point label is beyond the
7030 maximum length. Specify a valid
point label.
Description for the specified point is
7031 beyond the maximum length.
Specify a valid description.
Point file is corrupted. Check sum
7032
error.
Specified point file cannot be found.
7033
Specify a valid point file name.
7034 Cannot save the point file.
7035 Cannot save the point file.
7036 Cannot save the point file.
7037 Cannot save the point file.
7038 Cannot save the point file.
7039 Cannot save the point file.
The point label is not correct.
7040
Specify a valid point label.
The point label is not correct.
7041
Specify a valid point label.
7042 The pallet cannot be defined.
7043 Invalid point file version.
7044 Point file not supported format.
The specified work queue number is
7045
invalid.
7046 The specified work queue is full.
RC90 (EPSON RC+ 7.0) Rev.8
Remedy
Change the point label.
Change the comment.
Create the point file again.
Check the name of the specified point
file.
Failed to save the point file (create a
temporary file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (file open).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (renew the
file header).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (create the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (copy the
file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (change the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
The initial character of the point label
name is improper. Correct the label
name.
Inadequate character is used.
Correct the label name.
Undefined flag for pallet data is mixed.
Check the point data.
Correct the point data.
The point file version is different.
Re-create the point file.
The point file is not supported.
Re-create the point file.
Check the specified work queue number.
The work queue is full. Delete the
point data from the work queue and
register.
Maintenance 9. Troubleshooting
Note 1 Note 2
189