7.3 Changing Controller IP Address
In this section, the procedure to change the Controller IP address when connecting
Controller development PC connection port and the development PC by the USB cable is
indicated.
(1) For connection between the development PC and the Controller, refer to Setup &
(2) Select the EPSON RC+ 7.0 menu-[Setup]-[Controller] to display the following dialog.
(3) Select [Controller]-[Configuration].
(4) Enter the proper IP address and subnet mask and click the <Apply> button.
(5) Click the <Close> button. The Controller reboots automatically.
When the Controller and the development PC are connected via the Ethernet, the
NOTE
Controller IP address can also be changed. However, Controller and the development PC
do not connect automatically after rebooting the Controller at Ethernet connection.
RC90 (EPSON RC+ 7.0) Rev.8
Setup & Operation 7. LAN (Ethernet Communication) Port
Operation
5. Development PC Connection Port
IP address configuration is completed and the Controller reboot dialog disappears.
.
39