Epson RC90 Manual page 158

Maintenance 9. Troubleshooting
No. Message
Error message failure.
2432 Failed to obtain the header data of the
error message file.
Error message failure.
2433
Error message file is corrupted.
Error message failure.
2434 Specified a file other than the error
message file.
Error message failure.
2435 Version of the error message file is
invalid.
File Error.
2440
File number is already used.
File Error.
2441
Failed to open the file.
File Error.
2442
The file is not open.
File Error. The file number is being
2443
used by another task.
2444 File Error. Failed to close the file.
2445 File Error. File seek failed.
File Error.
2446
All file numbers are being used.
File Error.
2447
No read permission.
File Error.
2448
No write permission.
File Error.
2449
No binary permission.
File Error.
2450
Failed to access the file.
2451 File Error. Failed to write the file.
2452 File Error. Failed to read the file.
File Error.
2453 Cannot execute the command for
current disk.
2454 File Error. Invalid disk.
2455 File Error. Invalid drive.
2456 File Error. Invalid folder.
Database Error.
2460 The database number is already being
used.
Database Error.
2461
The database is not open.
Database Error.
2462 The database number is being used by
another task.
Windows Communication Error.
2470
Invalid status.
142
Remedy
Reboot the controller.
Reboot the controller.
Reboot the controller.
Reboot the controller.
Check the file number.
Make sure the file exists and you
specified the file correctly.
Open the file in advance.
Check the program.
Check the file.
Review the program.
Check the pointer setting.
Close unnecessary files.
Use ROpen or UOpen that has read
access to the file.
Use WOpen or UOpen that has write
access to the file.
Use BOpen that has binary access to the
file.
Check the file.
Check the file.
Check the file.
The specified command is not available
in the current disk (ChDisk).
Review the program.
Review the program.
Review the program.
Review the program.
Specify the number of other database.
Close the database.
Review the program.
Open the database.
Review the program.
Reboot the Controller.
Rebuild the project.
Note 1
RC90 (EPSON RC+ 7.0) Rev.8
Note 2