Epson RC90 Manual page 137

No. Message
1103 File is not found.
1104 Project file was not found.
1105 Object file was not found.
1106 Point files were not found.
The program is using a feature that is
1107 not supported by the current controller
firmware version.
One or more source files are updated.
1108
Please build the project.
1109 Not enough storage capacity.
1110 File is not found.
1111 Conveyor file was not found.
File failure.
1120
Setting file is corrupt.
File failure.
1121
Project file is corrupt.
File failure.
1122
Point file is corrupt.
File failure.
1123
I/O label file is corrupt.
File failure.
1124
User error file is corrupt.
File failure.
1126 Software option information is
corrupt.
File failure.
1127
Vision file is corrupt.
File failure.
1128
Backup information file is corrupt.
Error message failure.
1130
No item is found in the error history.
1131 Cannot access the USB memory.
File failure.
1132
Failed to copy the file.
File failure.
1133
Failed to delete the file.
File failure.
1134
GUI Builder file is corrupt.
File failure.
1140
Failed to open the object file.
File failure.
1141
Failed to open the project file.
File failure.
1142
Failed to read the project file.
File failure.
1143
Failed to open the condition save file.
RC90 (EPSON RC+ 7.0) Rev.8
Remedy
Check whether the file exists.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Check the compiler version in the
EPSON RC+
7.0-[Project]-[Properties]-[Compiler].
Rebuild the project.
Increase free space of the USB memory.
-
-
Restore the controller configuration.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Rebuild the project.
1. Reboot the controller.
2. Reinstall the firmware.
3. Reconfigure the option.
Rebuild the project.
The specified backup information cannot
be restored.
Acquire the backup information again,
and then restore the file.
No error history exists.
Reboot the controller.
Insert the USB memory properly. When
this error still occurs after the USB
memory is inserted properly, the
memory may be unrecognizable to
controller. Insert another memory to
check the operation.
-
-
Rebuild the project.
Rebuild the project.
Rebuild the project.
Rebuild the project.
1. Retry using the same USB memory.
2. Retry using another USB memory.
3. Retry after rebooting the controller.
Maintenance 9. Troubleshooting
Note 1 Note 2
121