Epson RC90 Manual page 142

Maintenance 9. Troubleshooting
No. Message
Timeout during connection via
1806
Ethernet.
1807 Timeout during connection via USB.
1808 USB driver is not installed.
Initialization failure.
1809
Failed to initialize PC daemon.
PC daemon error.
1810
Uncommon error.
Connection failure.
The connected controller is not
1812
supported in EPSON RC+ 7.0.
Please use EPSON RC+ 5.0.
System error.
1852
Uncommon error.
Initialization failure.
1861
Failed to initialize SimulatorMNG.
Initialization failure.
1862
Failed to initialize WBProxy.
1863 The parameter is invalid.
Initialization failure.
1864
Virtual controller does not exist.
Initialization failure.
1865
Failed to start virtual controller.
Cannot execute because it is not dry
1867
run mode.
Initialization failure.
1868
Directory cannot be found.
Connection failure.
1872 Files for simulator that used real
controller cannot be found.
Connection failure.
1873 Files for simulator that used virtual
controller cannot be found.
1874 Virtual Controller cannot be added.
Simulator Object failure.
1875 Cannot load data for the simulator
object.
Simulator Object failure.
1876 Cannot read data for the simulator
object.
Simulator Object failure.
1877 Cannot remove data from the
simulator object.
Simulator Object failure.
1878 Cannot update data for the simulator
object.
1879 Other virtual controllers are starting.
126
Remedy
-
-
Failed to install EPSON RC+ 7.0.
Install EPSON RC+ 7.0 again.
Reboot the System.
1. Reboot the EPSON RC+7.0.
2. Reboot the PC.
Connected controller is RC180 or RC90
compatible with EPSON RC+ 5.0.
Check the connection between the PC
and controller.
1. Reboot the EPSON RC+7.0.
2. Reboot the PC.
3. Reinstall the EPSON RC+ 7.0.
1. Reboot the EPSON RC+ 7.0.
2. Reboot the PC.
3. Reinstall the EPSON RC+ 7.0.
1. Reboot the EPSON RC+ 7.0.
2. Reboot the PC.
3. Reinstall the EPSON RC+ 7.0.
-
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
1. Retry after a while.
2. Reboot the PC.
Dry run mode is invalid.
Enable the dry run.
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
-
-
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
-
-
-
-
Other virtual controllers may be used in
the EPSON RC+ 5.0.
Or, the virtual controller may be already
used in another EPSON RC+7.0.
Note 1
RC90 (EPSON RC+ 7.0) Rev.8
Note 2