Epson RC90 Manual page 211

No. Message
7533 Camera is not supported by RC+7.0.
Camera firmware does not support
7534
new functions of RC+7.0.
Data from the Compact Vision is
7535
incorrect.
Compact Vision failed to export the
7536
status.
Incorrect ImgeSize value.
7537 Specified value is not supported by the
camera.
7538 ZoomFactor value is too small.
The camera does not support Code
7539
Reader.
7540 The camera does not support OCR.
7541 Insufficient data for teaching model.
Model window cannot be outside of
7542
image.
Calibration points have not been
7543
taught.
7544 Calibration must be fixed upward.
7545 Point was not defined.
RobotPlacePos has not been
7546
calibrated.
Camera IP address is out of current
7547
subnet.
7548 Camera was not detected.
Invalid Radius. Radius must be >=
7549
RadiusInner and <= RadiusOuter.
7550 OCR character does not exist.
7551 OCR option is not active.
RC90 (EPSON RC+ 7.0) Rev.8
Remedy
SC300/SC1200 is not supported by
RC+7.0.
Use CV1/CV2.
Update the camera firmware.
Initialize the camera.
Initialize the camera.
ImageSizeexceeding the camera
resolution cannot be specified. Correct
the property value.
Settable values are from 0.1 to 10.0.
Correct the property value.
Update the camera firmware.
Update the camera firmware.
Black or white image cannot be
registered as a model.
Correct the position of the model
window.
Teach the calibration point.
Sequence with the calibration data of the
upward fixed camera is only settable.
Teach the calibration point.
Click CalRobotPlacePos and calibrate
RobotPlacePos.
Correct the camera IP address.
Check the wiring of the camera.
Correct the property value.
Register the OCR character.
Enable the option.
Maintenance 9. Troubleshooting
Note 1 Note 2
195