Epson RC90 Manual page 174

Maintenance 9. Troubleshooting
No. Message
3280 StartPosition was not specified.
3281 TextAlign was not specified.
3282 TextAlign was not specified.
3283 TextAlign was not specified.
3284 WindowState was not specified.
3285 J1FLAG was not specified.
3286 J2FLAG was not specified.
3287 robotID was not specified.
3288 robotID/All was not specified.
3289 areaID was not specified.
3290 File number was not specified.
3292 Database type was not specified.
158
Remedy
StartPosition property setting value is not
specified in GSet statement. Refer to
GUI Builder 7.0 manual "StartPosition
Property" and specify a proper setting
value.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control type
cannot be identified because the control
is specified by a string variable. Refer
to GUI Builder 7.0 manual "TextAlign
Property" and specify a proper setting
value.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control is a
text box. Refer to GUI Builder 7.0
manual "TextAlign Property" and
specify a proper setting value.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control is
other than a text box. Refer to GUI
Builder 7.0 manual "TextAlign Property"
and specify a proper setting value.
WindowState property setting value is
not specified in GSet statement.
Refer to GUI Builder 7.0 manual
"WindowState Property" and specify a
proper setting value.
Specify 0 or 1, or an expression for
J1Flag value.
Specify 0 or 1, or an expression for
J2Flag value.
Specify a robot number.
Robot number or All is not specified in
InsideBox and InsidePlane function.
Specify a robot number which performs
intrusion detection, or All.
Area number is not specified in
InsideBox and InsidePlane function.
Specify an approach check area number
which returns status by an integer from 1
to 15.
File number is not specified in the
command related to file management.
Specify a file number by an integer from
30 to 63 or an expression.
Database type is not specified in
OpenDB statement. Refer to SPEL+
Language Reference "OpenDB
Statement" and specify a proper database
type.
Note 1
RC90 (EPSON RC+ 7.0) Rev.8
Note 2