Part Names And Functions; Part Names; Functions - Epson RC90 Manual

2.

Part Names and Functions

2.1 Part Names

(Left side)
(5)
(6)
(20)

2.2 Functions

(1) POWER switch
(2) AC IN
(3) LED
(4) Fan Filter
(5) Signature label
(6) MT label
(7) Controller Number label
(8) Connection Check label
RC90 (EPSON RC+ 7.0) Rev.8
(4)
(9)
(18)
(8)
(10) (11)
Turns ON or OFF the Controller.
The terminal block for 200VAC power input.
For details, refer to Setup & Operation 3.3.2 AC Power Cable.
The LED indicates current operation mode (ERROR, E-STOP, TEACH, AUTO, or
PROGRAM mode). For details, refer to Setup & Operation 2.3 LED.
A protective filter is installed in front of the fan to filter out dust.
Check the condition of the filter regularly and clean it when necessary. A dirty filter
may result in malfunction of the robot system due to temperature rise of the
Controller.
The serial number of the Controller and other information are shown.
The label indicates the specification number of the customized manipulator or
controller. If this label is attached to your manipulator or controller, it may require a
specific maintenance procedure. In this case, make sure to contact your dealer
before performing any maintenance procedures.
The serial number of the Controller is indicated.
The details of the Manipulator to be connected are recorded on
the label as shown in the right.
Manipulator model and Manipulator serial number.
Setup & Operation 2. Part Names and Functions
(19)
(3)
(20)
(12) (13) (14) (15) (16)
The label indicates the
(1)
(2)
(17) (7)
MANIPULATOR
LS3-401S 00002
13