Epson RC90 Manual page 138

Maintenance 9. Troubleshooting
No. Message
File failure.
1144
Failed to write the condition save file.
File failure.
1145
Failed to open the conveyor file.
File failure.
1146
Failed to read the conveyor file.
File failure.
1150
Error history is invalid.
File failure.
1151
Failed to map the error history.
File failure.
1152
Failed to open the error history file.
File failure.
1153
Failed to write the error history file.
File failure.
1155
Failed to open the settings file.
File failure.
1156
Failed to save the settings file.
File failure.
1157
Failed to read the settings file.
File failure.
1158
Failed to write the settings file.
MCD failure.
1160
Failed to open the MCD file.
MCD failure.
1161
Failed to read the MCD file.
MCD failure.
1163
Failed to save the MCD file.
MPD failure.
1165
Failed to open the MPD file.
MPD failure.
1166
Failed to read the MPD file.
MPD failure.
1168
Failed to save the MPD file.
MPL failure.
1170
Failed to open the MPL file.
PRM failure.
1181
Failed to replace the PRM file.
File failure.
1185 Failed to open the backup information
file.
File failure.
1186 Failed to read the backup information
file.
File failure.
1187 Failed to write the backup information
file.
File failure.
1188 Failed to save the backup information
file.
The backup data was created by an old
1189
version.
122
Remedy
1. Retry using the same USB memory.
2. Retry using another USB memory.
3. Retry after rebooting the controller.
Rebuild the project.
Rebuild the project.
1. Reboot the controller.
2. Replace the CF.
1. Reboot the controller.
2. Replace the CF.
1. Reboot the controller.
2. Replace the CF.
1. Reboot the controller.
2. Replace the CF.
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
-
-
-
1. Reboot the controller.
2. Reinstall the firmware.
1. Reboot the controller.
2. Reconfigure the robot.
-
-
-
-
Cannot restore the controller
configuration in the specified procedure
for using old backup data.
Check the backup data.
Note 1
RC90 (EPSON RC+ 7.0) Rev.8
Note 2