Troubleshooting Routing Policy Configuration; Ipv4 Routing Information Filtering Failure; Ipv6 Routing Information Filtering Failure - HPE 5800 Series Configuration Manual

BGP Local router ID is 4.4.4.4
Status codes: * - valid, > - best, d - damped,
Network
*> 4.4.4.0/24
*> 5.5.5.0/24
*> 6.6.6.0/24
The output shows that Switch D has learned only routes 4.4.4.0/24, 5.5.5.0/24, and 6.6.6.0/24
from AS 100.

Troubleshooting routing policy configuration

IPv4 routing information filtering failure

Symptom
The routing protocol is running properly, but filtering routing information failed.
Analysis
At least one item of the IP prefix list must be configured as permit mode, and at least one node in the
routing policy must be configured as permit mode.
Solution
Use the display ip ip-prefix command to display IP prefix list information.
1.
Use the display route-policy command to display routing policy information.
2.

IPv6 routing information filtering failure

Symptom
The routing protocol is running properly, but filtering routing information failed.
Analysis
At least one item of the IPv6 prefix list must be configured as permit mode, and at least one node of
the routing policy must be configured as permit mode.
Solution
Use the display ip ipv6-prefix command to display IP prefix list information.
1.
Use the display route-policy command to display routing policy information.
2.
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
NextHop
1.1.3.1
1.1.3.1
1.1.3.1
364
MED LocPrf PrefVal Path/Ogn
0 300 100i
0 300 100i
0 300 100i