How To Configure Ip Source Guard - Cisco Catalyst 2960 series Configuration Manual

How to Configure IP Source Guard

How to Configure IP Source Guard
Enabling IP Source Guard
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ip verify source [mac-check ]
5. exit
6. ip source binding mac-address vlan vlan-id ip-address interface interface-id
7. end
8. show running-config
9. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 interface interface-id
Example:
Switch(config)# interface gigabitethernet 1/0/1
Step 4
ip verify source [mac-check ]
Example:
Switch(config-if)# ip verify source
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1294
Purpose
Enables privileged EXEC mode. Enter your password
if prompted.
Enters the global configuration mode.
Specifies the interface to be configured, and enters
interface configuration mode.
Enables IP source guard with source IP address filtering.
(Optional) mac-check—Enables IP Source Guard with
source IP address and MAC address filtering.