Finding Feature Information - Cisco Catalyst 2960 series Configuration Manual

VLAN Access Control Lists
VLAN access control lists (ACLs) or VLAN maps access-control all packets (bridged and routed). You can
use VLAN maps to filter traffic between devices in the same VLAN. VLAN maps are configured to provide
access control based on Layer 3 addresses for IPv4. Unsupported protocols are access-controlled through
MAC addresses using Ethernet access control entries (ACEs). After a VLAN map is applied to a VLAN, all
packets (routed or bridged) entering the VLAN are checked against the VLAN map. Packets can either enter
the VLAN through a switch port or through a routed port after being routed.
This module provides more information about VLAN ACLs and how to configure them.
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Finding Feature Information, page 1245
Information About VLAN Access Control Lists, page 1246
How to Configure VLAN Access Control Lists, page 1248
Configuration Examples for ACLs and VLAN Maps, page 1257
Configuration Examples for Using VLAN Maps in Your Network, page 1260
Configuration Examples of Router ACLs and VLAN Maps Applied to VLANs, page 1262
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
54
C H A P T E R
1245