Verifying The Dai Configuration - Cisco Catalyst 2960 series Configuration Manual

Verifying the DAI Configuration

Verifying the DAI Configuration
To display and verify the DAI configuration, use the following commands:
Command
show arp access-list [acl-name]
show ip arp inspection interfaces [interface-id]
show ip arp inspection vlan vlan-range
Additional References
Error Message Decoder
Description
To help you research and resolve system error
messages in this release, use the Error Message
Decoder tool.
MIBs
MIB
All supported MIBs for this release.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1316
Description
Displays detailed information about ARP ACLs.
Displays the trust state and the rate limit of ARP
packets for the specified interface or all interfaces.
Displays the configuration and the operating state of
dynamic ARP inspection for the specified VLAN. If
no VLANs are specified or if a range is specified,
displays information only for VLANs with dynamic
ARP inspection enabled (active).
Link
https://www.cisco.com/cgi-bin/Support/Errordecoder/
index.cgi
MIBs Link
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs