Ipv4 Acl Switch Unsupported Features - Cisco Catalyst 2960 series Configuration Manual

Information About Configuring IPv4 Access Control Lists

IPv4 ACL Switch Unsupported Features

Configuring IPv4 ACLs on the switch is the same as configuring IPv4 ACLs on other Cisco switches and
routers.
The following ACL-related features are not supported:
• Non-IP protocol ACLs
• IP accounting
• Reflexive ACLs and dynamic ACLs are not supported.
• ACL logging for port ACLs and VLAN maps
Access List Numbers
The number you use to denote your ACL shows the type of access list that you are creating.
This lists the access-list number and corresponding access list type and shows whether or not they are supported
in the switch. The switch supports IPv4 standard and extended access lists, numbers 1 to 199 and 1300 to
2699.
Table 113: Access List Numbers
Access List Number
1–99
100–199
200–299
300–399
400–499
500–599
600–699
700–799
800–899
900–999
1000–1099
1100–1199
1200–1299
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1176
Type
IP standard access list
IP extended access list
Protocol type-code access list
DECnet access list
XNS standard access list
XNS extended access list
AppleTalk access list
48-bit MAC address access list
IPX standard access list
IPX extended access list
IPX SAP access list
Extended 48-bit MAC address access list
IPX summary address access list
Supported
Yes
Yes
No
No
No
No
No
No
No
No
No
No
No