Lldp Configuration Examples; Basic Lldp Configuration Example - HP 3100 Series Configuration Manual

Task
Display types of advertisable
optional LLDP TLVs.

LLDP configuration examples

Basic LLDP configuration example

Network requirements
As shown in
Switch B are connected to Ethernet 1/0/1 and Ethernet 1/0/2 of Switch A.
Enable LLDP globally on Switch A and Switch B to perform the following tasks:
•
Monitor the link between Switch A and Switch B on the NMS.
•
Monitor the link between Switch A and the MED device on the NMS.
Figure 66 Network diagram
Configuration procedure
Configure Switch A:
1.
# Enable LLDP globally.
<SwitchA> system-view
[SwitchA] lldp enable
# Enable LLDP on Ethernet 1/0/1. By default, LLDP is enabled on ports.
[SwitchA] interface ethernet 1/0/1
[SwitchA-Ethernet1/0/1] lldp enable
# Set the LLDP operating mode to Rx.
[SwitchA-Ethernet1/0/1] lldp admin-status rx
[SwitchA-Ethernet1/0/1] quit
# Enable LLDP on Ethernet 1/0/2. By default, LLDP is enabled on ports.
[SwitchA] interface ethernet 1/0/2
[SwitchA-Ethernet1/0/2] lldp enable
# Set the LLDP operating mode to Rx.
[SwitchA-Ethernet1/0/2] lldp admin-status rx
[SwitchA-Ethernet1/0/2] quit
Configure Switch B:
2.
# Enable LLDP globally.
Figure 66, the NMS and Switch A are located in the same Ethernet. An MED device and
Command
display lldp tlv-config [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
188
Remarks
Available in any
view