Table of Contents
Advertisement
Operator information
panel assembly
Figure 168. Operator information panel removal
Step 6.
Pull out and rotate the release latch of the operator information panel assembly to release it from
the server.
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing the operator information panel assembly
Use this information to install the operator information panel assembly.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install the operator information panel assembly, complete the following steps.
Step 1.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 182).
Step 2.
Open the bezel (see "Removing the bezel" on page 184).
Step 3.
Remove the air baffle (see "Removing the air baffle" on page 188).
Step 4.
Remove the fan cage assembly (see "Removing the fan cage assembly" on page 261).
Step 5.
Touch the static-protective package that contains the operator information panel assembly to any
unpainted metal surface on the server; then, remove the assembly from the package.
Step 6.
Angle the operator information panel assembly, so, its edge can fit into the guide slot.
Release latch
1
.
Chapter 6
Removing and replacing components
249
Advertisement
Table of Contents
Troubleshooting
