Lenovo System x3500 M5 Type 5464 Installation And Service Manual page 138

[access_method]
The access method that you select to use from the following methods:
• Online authenticated LAN access, type the command: [­­imm
imm_user_id:imm_password@imm_internal_ip]
Where:
imm_internal_ip
The IMM2.1 internal LAN/USB IP address. The default value is 169.254.95.118.
imm_user_id
The IMM2.1 account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM2.1 account password (1 of 12 accounts). The default value is PASSW0RD (with
a zero 0 not an O).
Note: If you do not specify any of these parameters, Lenovo ToolsCenter Suite CLI will use the
default values. When the default values are used and Lenovo ToolsCenter Suite CLI is unable to
access the IMM2.1 using the online authenticated LAN access method, Lenovo ToolsCenter
Suite CLI will automatically use the unauthenticated KCS access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted): You do not need to specify a value for
access_method when you use this access method.
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI
driver be installed. Some operating systems have the IPMI driver installed by default. Lenovo
ToolsCenter Suite CLI provides the corresponding mapping layer. To download the Lenovo
ToolsCenter Suite CLI Users Guide, do the following:
1. Go to http://www.lenovo.com/support.
2. Click Downloads tab at the top of the panel.
3. Under ToolsCenter, select View ToolsCenter downloads.
4. Select Lenovo ToolsCenter Suite CLI.
5. Scroll down and click the link and download the correct version for your operating system.
Scroll down and look under Online Help to download the Lenovo ToolsCenter Suite CLI
Users Guide.
The following commands are examples of not using the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access IMM2.1 using the LAN from a
client, the host and the imm_external_ip address are required parameters.
[­­imm imm_user_id:imm_password@imm_external_ip]
Where:
imm_external_ip
The external IMM2.1 LAN IP address. There is no default value. This parameter is required.
122
System x3500 M5 Installation and Service Guide