Table 12. Light path diagnostics panel LEDs (continued)
LED
Look at the system service label on the top of the server, which gives an overview of internal components
that correspond to the LEDs on the light path diagnostics panel. This information can often provide enough
information to diagnose the error.
Power-supply LEDs
This section describes the power-supply LEDs on the rear of the server and the suggested actions to
correct the detected problems.
The following illustration shows the power-supply LEDs on the rear of the server.
Figure 95. Power-supply LEDs on the rear of the server
Error
DC power
AC power
(Amber)
(Green)
(Green)
The following table describes the problems that are indicated by various combinations of the power-supply
LEDs and the system power LED on the operator information panel and suggested actions to correct
the detected problems.
Description
2. Check the system-event logs for information about
3. Replace the failing component:
Action
• (Trained technician only) System board (see
"Removing the system board" on page 288 and
"Installing the system board" on page 291).
the error.
• Battery
• Microprocessor 2 expansion board
• Power paddle card
• (Trained technician only) System board
Ethernet link LED
Ethernet activity LED
Chapter 4
137
.
Troubleshooting