Table of Contents
Advertisement
Step 4.
Select Add Boot Option; then, select Generic Boot Option ➙ Embedded Hypervisor. Press
Enter, and then select Esc.
Step 5.
Select Change Boot Order ➙ Change the order. Use the Up arrow and Down Arrow keys
to select Embedded Hypervisor and use the plus (+) and minus (-) keys to move Embedded
Hypervisor in the boot order. When Embedded Hypervisor is in the correct location in the boot
order, press Enter. Select Commit Changes and press Enter.
Step 6.
Select Save Settings and then select Exit Setup.
If the embedded hypervisor flash device image becomes corrupt, go to
http://www.ibm.com/systems/x/os/vmware/esxi/ and follow the instructions on the screen.
For additional information and instructions, see VMware vSphere 4.1 Documentation at
http://www.vmware.com/support/ pubs/vs_pages/vsp_pubs_esxi41_e_vc41.html or the VMware vSphere
Installation and Setup Guide at http://pubs.vmware.com/vsphere-50/topic/ com.vmware.ICbase/PDF/
vsphere-esxi-vcenter-server-50-installation-setup-guide.pdf.
Configuring the Ethernet controller
Use this information to configure the Ethernet controller.
The Ethernet controllers are integrated on the system board. They provide an interface for connecting
to a 10 Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables
simultaneous transmission and reception of data on the network. If the Ethernet ports in the server support
auto-negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and
duplex mode (full-duplex or half-duplex) of the network and automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must install a device driver to
enable the operating system to address the controllers.
To find device drivers and information about configuring the Ethernet controllers, go to
http://www.lenovo.com/support.
Enabling Features on Demand Ethernet software
Use this information to enable Features on Demand Ethernet software.
You can activate the Features on Demand (FoD) software upgrade key for Fibre Channel over Ethernet
(FCoE) and iSCSI storage protocols that is integrated in the Integrated Management Module II (IMM2).
For more information and instructions for activating the Features on Demand Ethernet software key, see
the Features on Demand User's Guide. To download the document, go to https://fod.lenovo.com/lkms,
log in, and click Help.
Enabling Features on Demand RAID software
Use this information to enable Features on Demand RAID software.
You can activate the Features on Demand (FoD) software upgrade key for RAID that is integrated in the
integrated management module. For more information and instructions for activating the Features on
Demand RAID software key, see the Features on Demand User's Guide. To download the document, go to
https://fod.lenovo.com/lkms, log in, and click Help.
Configuring RAID arrays
Use the Setup utility to configure the RAID arrays.
116
System x3500 M5 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
