Note: In order to avoid damage to the ODD/DVD and/or tape drive and/or media, remove the
bezel filler.
Figure 99. Remove the bezel filler
Closing the bezel door
Use this information to close the bezel media door.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To close the bezel door, complete the following steps.
Step 1.
Swing the bezel door to close it.
Step 2.
From the left-top section of the bezel door, use the key to turn the tab down to lock the left-side
cover and the bezel door
Bezel filler
.
Chapter 6
Removing and replacing components
181