Table of Contents
Advertisement
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install an optional full-height tape drive, complete the following steps.
Step 1.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 182).
Step 2.
Open the bezel (see "Removing the bezel" on page 184).
Step 3.
Remove the EMC shields from the drive bay, if installed.
Step 4.
Touch the static-protective package that contains the tape drive to any unpainted metal surface
on the server; then, remove the tape drive from the package.
212
System x3500 M5 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
