Installing The Operator Information Panel Assembly - Lenovo System x3500 M4 Installation And Service Manual

Handle
Figure 176. Operator information panel removal
Step 8. Push up on the release latch while you pull the operator information panel assembly toward the
rear of the server; then, angle the back of the assembly toward the system board and remove the
assembly from the server.
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.

Installing the operator information panel assembly

Use this information to install the operator information panel assembly.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 35.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install the operator information panel assembly, complete the following steps.
Step 1. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 184).
Step 2. Remove the air baffle (see "Removing the air baffle" on page 189).
Step 3. Remove the fan cage assembly (see "Removing the fan cage assembly" on page 272).
Step 4. Disconnect the drive cables from the back of the drive bay 1.
Step 5. Remove the DVD drive (see "Removing a DVD drive" on page 205) or the tape drive (see "Removing
an optional tape drive" on page 208) which is installed in drive bay 1.
Step 6. Touch the static-protective package that contains the operator information panel assembly to any
unpainted metal surface on the server; then, remove the assembly from the package.
Step 7. Angle the operator information panel assembly so that the edge of the assembly is in the guide slot.
260
System x3500 M4 Installation and Service Guide
Operator information
panel assembly