Lenovo System x3500 M5 Type 5464 Installation And Service Manual page 124

This choice is on the full Setup utility menu only.
• System Settings
Select this choice to view or change the server component settings.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0 compliant adapters and
drivers installed in the server.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output (I/O) ports. You can
configure the serial ports, configure remote console redirection, enable or disable integrated Ethernet
controllers, the SAS/SATA controllers, SATA optical drive channels, PCI slots, and video controller. If
you disable a device, it cannot be configured, and the operating system will not be able to detect it
(this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption, processors, and
performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and power utilization).
– Legacy Support
Select this choice to view or set legacy support.
Note: In the legacy mode, this system has limited ROM space for installed options. At most four
network interface cards (NICs) are supported for legacy PXE boot. If more than four NICs are
installed, legacy PXE boot will not be attempted on some of the NICs. To enable legacy PXE boot on
the desired NIC connectors, prioritize the desired NIC connectors by changing the ROM execution
Order or disable the NIC connectors that you do not use from the Enable/Disable Adapter Option
ROM Support menu.
– Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not support UEFI video
output standards.
– Rehook INT 19h
Select this choice to enable or disable devices from taking control of the boot process. The default
is Disable.
– Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass storage devices that are
non-UEFI compliant. The default is Enable.
– Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy boot order. The default
is Disable.
– BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The default is Enable.
– System Security
108
System x3500 M5 Installation and Service Guide