Lenovo System x3500 M5 Type 5464 Installation And Service Manual page 219

Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side
cover, it locks both the cover and the bezel.
Step 2. Open the bezel (see "Removing the bezel" on page 184).
Step 3. Press the latch to open the drive handle. Then, rotate the drive handle to the open position.
Step 4. Grasp the handle and pull the drive out of the drive bay.
2
3.5-inch filler panel
Figure 122. Pull out the drive
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing a 3.5-inch hot-swap hard disk drive
Use this information to install a 3.5-inch hot-swap SAS/SATA hard disk drive.
Before installing a 3.5-inch hot-swap hard disk drive, read the following information:
• Inspect the drive tray for signs of damage.
• To maintain proper system cooling, do not operate the server for more than 10 minutes without either a
drive or a filler panel installed in each drive bay.
• You do not have to turn off the server to install hot-swap drives in the hot-swap drive bays.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install a 3.5-inch hot-swap SAS/SATA hard disk drive, complete the following steps.
Step 1. Unlock the left-side cover.
3.5-inch hot-swap
hard disk drive
Latch
1
Handle
.
Chapter 6 Removing and replacing components
203