Table of Contents
Advertisement
Cable clip
Figure 201. SAS, power and operator information panel cable insertion
Step 6.
Install the bezel (see "Replacing the bezel" on page 198).
Step 7.
Install the cover (see "Replacing the cover" on page 196).
Step 8.
Insert the video and USB breakout cable (see "Replacing the front video and USB breakout
cable" on page 272).
Step 9.
Slide the server into the rack.
Step 10. Reconnect the power cords and any cables that you removed.
Step 11. Turn on the peripheral devices and the server.
Removing the operator information panel assembly
Use this information to remove the operator information panel assembly.
To remove the operator information panel, complete the following steps.
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Remove the cover (see "Removing the cover" on page 195).
Step 4.
Disconnect the cable from the back of the operator information panel assembly.
278
Lenovo System x3650 M4 HD Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
