Table of Contents
Advertisement
Battery / flash power
module holder
Figure 110. Battery or flash power module holder removal
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing a RAID adapter battery or flash power module holder
Use this information to install a RAID adapter battery or flash power module holder.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install a RAID adapter battery or flash power module holder, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
1
.
Chapter 6
Removing and replacing components
191
Advertisement
Table of Contents
Troubleshooting
