Checking Addresses; Re-Grouping; Re-Group And Check Setting Options - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

612 Checking addresses

Path: SERVICE MENU / EXTERNAL / RE-GROUP AND CHECK
Figure 144: RE-GROUP AND CHECK settings level
– Start point: RE-GROUP AND CHECK settings level
= BUS ADDR. illuminates.
1. Run your finger along the touchring until the desired bus address appears.
= Group address appears.
2. Select CHECK POSSIBLE.
3. Press the on/off key multiple times.
= Output status changes when the key is pressed (e.g. luminaire adjusts between 100% and 0%).
4. Run your finger along the touchring.
= Output status changes (e.g. luminaire brightens or dims).
5. If the address is correct, select BACK.
= The previous selection level appears.
Note
• The address can be changed if it is found to be incorrect (see Section
Parameter
BUS ADDR.
Table 42: RE-GROUP AND CHECK setting options
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Value range
Bus addresses available in the
room
Commissioning the field level
6.1.3

Re-grouping).

87