Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use page 72

Notes
• Only addresses with the same room number as the LM-CIRIA control unit are imported. If no room
number is assigned to the LM-CIRIA control unit, the message NO ROOM ADDRESS is displayed.
• If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex- If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex- If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex-
isting in this room will be imported.
• If the LM-CIRIA control unit has been assigned a room and group address, only the bus addresses
existing in this room and in this group will be imported.
5952 Expanding the list of icons
Note
• To configure the group and building service icons, it is recommended to commission the field level
first (see Section 6
Path: SERVICE MENU / INTERNAL / CONFIGURATION / SYMBOL BUILD-UP
Figure 130: SYMBOL BUILD-UP
– Start point: SYMBOL BUILD-UP settings level
1. Select MODE.
= MODE illuminates.
2. Run your finger along the touchring until EXTEND SYMBOLS appears.
3. Select START.
= New addresses on the LM-Bus are imported.
= The status display appears until all addresses are imported.
Figure 131: Status display ... IN PROGRESS ....
= When the data for all addresses and for the building service types have been imported, the previ-
ous selection level appears.
Notes
• Only addresses with the same room number as the LM-CIRIA control unit are imported. If no room
number is assigned to the LM-CIRIA control unit, the message NO ROOM ADDRESS is displayed.
• If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex- If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex- If the LM-CIRIA control unit has only been assigned a room address, only the group addresses ex-
isting in this room will be imported.
• If the LM-CIRIA control unit has been assigned a room and group address, only the bus addresses
existing in this room and in this group will be imported.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Commissioning the field
settings level
Configuring the LM-CIRIA control unit
address, only the group addresses ex- , only the group addresses ex-
level).
72