On/Off Key - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

33 Touchring
Figure 15: Touchring
The touchring is used to change scenes temporarily (changes are not saved) and to navigate to de-
sired values in the settings levels. The touchring is touch-sensitive; to use it, run your finger along the
ring. When the touchring is touched or when you remove your finger from it, the touchscreen display
changes.

34 On/off key

Figure 16: On/off key
The on/off key is used to recall a presence or absence scene. The scene to be used for presence or
absence scenes is set when the system is commissioned and then assigned to the on/off key. If the
absence scene is enabled, the on/off key LED is illuminated white to enable the control unit to be found
in the dark. If a presence scene is recalled, the on/off key LED goes out. The behaviour of the on/off
key LED is set when the system is commissioned.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
LM-CIRIA control unit
16