Table of Contents
Advertisement
Assigning a waiting time
Figure 176: NEXT SCENE settings level
– Start point: NEXT SCENE settings level
1.
Select NEXT STEP.
= WAITING TIME settings level appears.
Figure 177: WAITING TIME settings level
2.
Select MINUTES.
= MINUTES illuminates.
3.
Run your finger along the touchring until the desired number appears.
4.
Select SECONDS.
= SECONDS illuminates.
5.
Run your finger along the touchring until the desired number appears.
6.
Select SAVE to save the settings.
= The message SAVED briefly appears.
= Waiting time is saved.
Notes
• Settings are only saved if SAVE is selected.
• Selecting SAVE automatically saves all values displayed on the touchscreen.
• To switch to the NEXT SCENE settings level directly (without saving), select NEXT STEP.
7.
Select NEXT STEP to switch to the NEXT SCENE settings level.
8.
To configure more scenes, start in the NEXT SCENE settings level and select the next scene.
9.
To exit the scene sequence configuration, configure the stop scene (see Section
Configuring stop
scenes).
Parameter
MINUTE
SECONDS
Table 74: WAITING TIME setting options
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Commissioning the field level
Value range
0 – 59
0 – 59
6.9.1.4
113
Advertisement
Chapters
Table of Contents
