F Questions And Answers - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

Appendix

F Questions and answers

How many scene icons can be configured?
Up to 20 scene icons can be configured in the entry level. The entry level is limited to 30 icons (both
scene and building service icons).
How many group icons can be configured?
Up to 15 group icons can be configured.
How many building service icons can be configured?
Up to 30 building service icons can be configured in the entry level. The entry level is limited to 30 icons
(both scene and building service icons).
How do I operate individual groups?
The GROUPS icon is located in the entry level.
1. Select GROUPS to access the selection level where you can select individual groups for operation.
2. Select the group to be operated.
= The settings level for operation appears.
3. Select the corresponding icon to operate the group.
How can I access the entry level directly from the service menu?
Select and hold BACK for approximately two seconds.
On which bus systems can the LM-CIRIA control unit be operated?
The LM-CIRIA control unit can only be operated on the LM-Bus.
Is the LM-CIRIA control unit powered by the LM-Bus?
No, the LM-CIRIA control unit must have a separate power supply (230/240 V AC, 50/60 Hz).
Why does the on/off key LED sometimes illuminate when I am in the service menu?
The on/off key LED illuminates when the on/off key must be pressed in order to save settings.
Is a new icon automatically created for a group if an output is re-grouped to a new group ad-
dress?
No. A group icon can be created in the service menu in the SYMBOL BUILD-UP settings level using
the EXTEND SYMBOLS parameter.
What happens if the LM-CIRIA control unit is reset to its factory settings?
The entry level is reset to contain only the DESK, MEETING and BEAMER scene icons and the
BRIGHTNESS, BLINDS, SCREEN and WINDOW building service icons. The other building service
icons in the entry level and in the selection levels are deleted. The LM-CIRIA control unit is reset to the
parameter values listed in Section E of the Appendix which details the factory settings. The language
setting is not reset.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en 133